3/8 Inch Crushed Stone for Pathways in Hill, NH

New Hampshire Rock Supply handles gravel and aggregate delivery in Hill, NH, and we stock the materials this ground actually calls for. Crushed gravel is the base most drives and pads here start with. So is stone dust, the fines that make a path walkable. We also carry washed stone, sand, loam and decorative rock for the rest of the yard.

Hill sits in the Lakes Region, where stony glacial till and ledge push up through the hills and leave thin, bony soil behind. That shapes what you order and how deep you put it.

Materials for Hill Projects

Paths and walkways are where most Hill homeowners notice the difference between materials. A path wants fines that lock together underfoot instead of loose stone that rolls and scatters. Here are the materials that do that job, plus the base that supports them.

Stone Dust, also called screenings or crusher dust, is the New England default under flatwork and the top pick for a compacted path. It binds hard once you wet and plate it, so wheels and boots stop sinking. For paver and flagstone bedding, this is the layer that keeps the surface flat.

Walkway Gravel is the finer, walkable surface for garden paths and foot traffic. It knits together at the surface and stays tidier than loose stone.

3/8" Crushed Stone works as fine drainage and pipe bedding, and as a topping over a compacted base. On a path it stays put better than larger clean stone.

Pea Stone, which most New Hampshire yards call Natural Pea Gravel, suits walkways, play areas and light drainage. It drains fast and stays comfortable underfoot.

Under any of those, you still need a compacting base. Crusher Run binds and compacts, and Crushed Gravel is the standard New Hampshire base for drives, parking pads and shed bases.

For drainage below or beside a path, Drain Rock handles French drains, drywells and downspout runs. RipRap armors banks and culvert outlets against runoff.

Ground and Conditions in Hill

A path that fails here usually fails from a base that was too thin. The frost heaves under gravel drives and camp roads prove the point every spring, and a path laid straight on frozen till will not stay flat.

Soft till needs more base under it and a way to shed water. Dig out the soft till, lay a compacted base of crushed gravel or crusher run, then cap it with stone dust or walkway gravel. Frost depth runs about 4 feet in most towns, and the town building official sets footing depth.

Snowmelt and mud season saturate the till soils, and runoff from drives and sloped lots flows toward the lakes and ponds. The sandy plains drain fast by contrast, so your base depth can change from one lot to the next. Base and driveway work runs from the end of mud season into late fall.

Delivery to Hill and the Surrounding Area

Ordering by the ton is the safer route when you know the area and depth you are covering. Ordering by the yard suits materials you buy by volume, and the two are not the same number. Decide which one your project needs before you order.

Estimate by measuring length, width and depth, then let the calculator turn those into cubic yards. A thin path takes far less than it looks, and a driveway base takes more than most people guess.

We deliver bulk loads across Merrimack County, including Concord, Hooksett, Franklin, Bow and Henniker. Tell us where the pile should sit, and keep the path to it clear and firm enough for a loaded truck.

Questions About Ordering in Hill

What should I have ready when the truck arrives?

Have the drop spot marked and the access clear. A loaded truck needs firm, level ground and room to turn, and it cannot cross soft till or a weak culvert. Move vehicles and anything breakable out of the way. If you are unsure, walk the route first and flag low branches or wires.

What is the best base under pavers in Hill?

Crushed gravel or crusher run makes the compacted base, then stone dust goes directly under the pavers as bedding. The stone dust is what sets flat and stays flat, and it is the New England default under flatwork. Give the base enough depth so spring frost heaves do not lift the surface.

Get Your Hill Material Quantity Right

Use the quantity calculator before you order, so the tons or yards match your actual area and depth. Then place your order online and we will deliver the load to your site in Hill.